02.01.2006, 13:05
Hallo C6 Freunde
hier eine wichtige Information aus dem US-Corvette Forum. Auf jeden Fall beim Update des NAV beachten, sonst wird das Gerät defekt und muß ausgetauscht werden (Garantie?!)
If you are going to upgrade your radio yourself then a word of caution.
BEFORE YOU START THE UPGRADE PROCEDURE
Turn the ignition "on" with the engine "off" by holding the ignition switch in "ACC" mode for at least 10 seconds.
I'll say it again.
Turn the ignition "on" with the engine "off" by holding the ignition switch in "ACC" mode for at least 10 seconds.
Louder this time for those who did not hear it.
Turn the ignition "on" with the engine "off" by holding the ignition switch in "ACC" mode for at least 10 seconds.
You do this to keep the car from powering down in the middle of the install because if it powers down:
• If the vehicle is turned "off" during updating, the "software updating" process may not work and a new navigation radio will be required.
One person has already fried their Nav radio from not following the instructions to the letter.
Also den 'ACC' Knopf mindestens 10 Sekunden drücken bevor man mit dem Update beginnt. Dies verhindert das nach einer gewissen Zeit von 'ACC' auf 'Off' geschaltet wird.
Grüße
hier eine wichtige Information aus dem US-Corvette Forum. Auf jeden Fall beim Update des NAV beachten, sonst wird das Gerät defekt und muß ausgetauscht werden (Garantie?!)
If you are going to upgrade your radio yourself then a word of caution.
BEFORE YOU START THE UPGRADE PROCEDURE
Turn the ignition "on" with the engine "off" by holding the ignition switch in "ACC" mode for at least 10 seconds.
I'll say it again.
Turn the ignition "on" with the engine "off" by holding the ignition switch in "ACC" mode for at least 10 seconds.
Louder this time for those who did not hear it.
Turn the ignition "on" with the engine "off" by holding the ignition switch in "ACC" mode for at least 10 seconds.
You do this to keep the car from powering down in the middle of the install because if it powers down:
• If the vehicle is turned "off" during updating, the "software updating" process may not work and a new navigation radio will be required.
One person has already fried their Nav radio from not following the instructions to the letter.
Also den 'ACC' Knopf mindestens 10 Sekunden drücken bevor man mit dem Update beginnt. Dies verhindert das nach einer gewissen Zeit von 'ACC' auf 'Off' geschaltet wird.
Grüße
JRStrade