Reifenwechsel auf Magnesiumfelgen

[cookolux]

Die einzige Software die Dein Haendler braucht ist ein Magnet

Resetting Tire Pressure Monitors -- 1 of 1
Date Published: 2001-07-02



I used this message forwarded from a fellow forum member and it worked just as described. Thought I would post for anyone else that may need to reset their TPMs.

1) Turn ignition on
2) Press "Reset" button in order to clear any IPC display warning messages
3) Press and release the "Options" button on the DIC to scroll through the
display options until the IPC display is blank
4) Press and hold the DIC "Reset" button for 3 seconds
5) Press the "Options" button again until TIRE TRAINING message appears
6) Press "Reset" button until the IPC "Learn L Front Tire" message appears in
order to begin the programming
7) Install the J41760 Tire Pressure Monitor (TPM) System Programming Tool
(large magnet will do) over the left front valve stem
8) The horn will sound, indicating the left front TPM sensor is programmed
(if this takes more than 15 seconds, pull magnet back and try again, it will
give you three tries. Then you must start over)
9) When the horn sounds, proceed to program the next TPM sensor in the
following order as directed by the IPC messages:
-Learn R Front Tire
-Learn R Rear Tire
-Learn L Rear Tire

Programming can be canceled by turning ignition off, waiting 2 minutes with
no sensors being learned, finishing all 4 wheels or through the DIC.

If the programming is canceled with less than 4 sensors learned, it will only
accept the codes programmed up to that point.